03-07 LS Vortec Standalone Wire Harness Drive By Wire W/4L80E 4.8. These harnesses are designed for retrofitting'03 -'07 Vortec engines (4.8, 5.3, 6.0-Liter) and 4L80E transmissions into older muscle cars and street rods or newer non-emissions controlled vehicles. Harness allows use of the factory Vortec intake manifold. They are completely plug and play with four wire hookup (switched power, constant power and ground connections required).
Harnesses are designed with a sliding grommet seal and 4 - 5 feet of length from the rear of the cylinder head to the PCM mounting position under the vehicle dashboard. A sliding grommet seal allows for professional, leak proof installation. Harnesses are professionally constructed from Brand New GM Delphi Connectors and TXL (Polyethylene Cross Linked) High Temperature Wire to GM Specifications. Complete Engine and Transmission Harness.
CHECK WITH US IF YOU ARE UNSURE ABOUT FITMENT. Harness allows use of the factory Vortec intake manifold and Delphi/multec injectors with flex-fuel injectors (EV6) and EV1 optional. WE ARE CAPABLE OF ASSISISING WITH YOUR INSTALL THROUGH OUR TECH SUPPORT.BUT, WE ENCOURAGE OUR CUSTOMERS TO SEEK A PROFESSIONAL FOR YOUR INSTALLATION. SOME ADAPTIONS MIGHT BE NECCESSARY FOR THIS PRODUCT TO WORK FOR YOUR VEHICLE. 1200 Degree Fiberglass Braid on All Circuits Ran by Heat....
All Factory CPA (Connector Position Assurance Locks). 115 x 35 x 2 inches; 5 Pounds. 2003,2004,2005,2006,2007. With forward-looking safety thinking and mature technology, we are committed to creating an ecological circle where people, cars and life interact organically and create a better and more reliable travel life.We will reply you within 24 hour. Feedback is very important to us.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Air & Fuel Delivery\Fuel Injection Parts\Additional Fuel Injection Parts". The seller is "accupi-healthcare" and is located in this country: US. This item can be shipped to United States.